![]() ![]() If you use a buckle, consider covering it with tubular webbing to avoid scratching the mast. Lubricate the strap and the underside of the boom with a dry lubricant such as McLube Sailkote. Obviously, there can be no hardware on the sides or bottom of the boom within the sliding range. When the outhaul is eased, the clew automatically slides forward in all but the lightest airs. Flattening the sail requires only a firm pull and no purchase, and a winch is needed if there is wind in the sail. With a clew strap, the clew moves nearly as easily as a traveler car system. Flattening the sail required using a winch, even with no wind pressure, because the cloth had to be forcibly stretched. The original sail, with attached foot and sail slugs, often stuck in lighter winds, requiring pushing against the center of the sail foot to get the clew to slide in and the sail to increase in fullness. This wasn’t our first loose footed sail, but it was the first wed installed on a boat that was not factory equipped for this. In truth, that simple webbing strap would have lasted the life of the sail, but as dedicated tinkerers, we soon replaced it with an adjustable strap with a buckles, which has functioned well for five years. When we rigged our new main on our test boat, the existing sail slugs didn’t make us happy, so we lashed the clew to the boom with a sail tie, wrapping it twice and securing with several half hitches. ![]() ![]() Sailmakers don’t always include this simple device with a new sail, since they don’t know what hardware you have or what your preferences may be. They became standard equipment on larger race boats as well, including Farr 40s and TP 52s. Simple Velcro wraps first appeared on racing dinghies such as Lasers, where they provided a lightweight solution that adjusted smoothly, allowed for fast sail installation and removal, and eliminated complicated and heavy track systems. Unfortunately, the car or slugs are often undersized or prone to jamming without help from an attached foot. For most boats, switching to a loose footed sail is as simple as attaching the clew shackle to the existing final slider (reinforced slugs are made for this purpose) or car. In a loose footed sail, the clew patch is slightly enlarged to compensate. In fact, the sheet load will always be carried in a radial pattern originating from the clew, with most of the load carried by the clew ring. Most new mainsails are loose footed.Ī common misconception, or at least exaggeration, is that an attached foot provides better support for the sail. Both are used on both high performance and cruising boats. A sail with an attached foot, secured to the boom with a bolt rope or sail slugs, has a small advantage in area, while a loose footed sail is easier to adjust (flat for windward work and smooth seas, fuller for reaching and rough seas), slightly cheaper to fabricate, and much easier to take off the boom for storage. You'll be sent the next issue of our newsletter shortly.īecause our price on this item is lower than the manufacturer's Minimum Advertised Price, the manufacturer does not allow us to display our retail price until you place the item in your shopping cart.Īdding the item to your cart allows The Chandlery to show you our price consistent with our goal of offering the lowest possible price on the widest selection of products.Īdding this product does not require you to purchase the item, and you can easily remove it from your cart if you decide not to buy it.After settling on the material, one of the most basic mainsail design questions is whether to have an attached foot or loose-foot. We will process this price request and send you details within 24 hours. What your needs are, and receive a price from us within 24 hours during weekdays. Briefly summarize any additional products or accessories you are interested in, or ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |